PCB Repair Technician

Position Summary

The Electronics Technician will support troubleshooting, repair, and testing of telecommunications equipment to the board and component level under the guidance of senior engineers and technicians.

Required Skills & Qualifications

Education

Associate degree or technical diploma in Electronics Technology, Electrical Engineering Technology, Telecommunications, or related field
OR equivalent military or hands-on technical training

Technical Skills

Electronics Fundamentals

Basic understanding of analog and digital circuit principles
Ability to read and interpret schematics, wiring diagrams, and PCB layouts
Understanding of:
- Ohm’s Law and basic circuit analysis
- AC/DC circuits
- Power supplies
- Digital logic fundamentals

Component-Level Knowledge

Ability to identify and test:
- Resistors, capacitors, inductors
- Diodes and transistors
- Basic ICs
Familiarity with component datasheets
Basic fault isolation to board or component level (with supervision)

Test & Measurement Skills

Hands-on experience using:
- Digital multimeter
- Oscilloscope
- Signal generator (preferred)
Ability to perform basic signal tracing and voltage/current measurements
Understanding of safe equipment handling procedures

Telecommunications & RF Exposure (Preferred but Not Required)

Basic understanding of RF concepts
Exposure to telecommunications equipment such as routers, radios, or fiber systems
Awareness of regulatory standards (e.g., Federal Communications Commission (FCC))

Hardware & Repair Skills

Basic soldering skills (through-hole and surface mount)
Ability to replace components on printed circuit boards
Familiarity with ESD-safe handling practices
Experience using hand tools and rework stations

Software & Digital Skills

Basic understanding of embedded systems
Familiarity with serial interfaces (UART, SPI, I2C) preferred
Basic computer skills (Windows/Linux environment)
Ability to follow test procedures and log results accurately
Soft Skills
Strong troubleshooting mindset
Willingness to learn and accept technical guidance
Attention to detail
Good written and verbal communication skills
Ability to work in a team environment

Key Responsibilities

Perform diagnostic testing of telecommunications equipment
Assist in troubleshooting failures to board or component level
Replace defective components and verify repairs
Document repair actions and test results
Follow safety and quality procedures
Ability to lift equipment up to 45 lbs.

Pay range is $17 to $20 an hour depending on experience